Features

This Pet Door is designed for cats and small dogs that below 7kg, with Fitting instructions and screws it is easy to mount. This pet door features with 4 way locking system. 

 

Features: 

Barrier locking system

Suitable for cats and small dogs, up to 7kg(15lbs).

Fit wooden doors, brick walls, PVC/UPVC doors.

Fitting instructions and screws included

 

Overall size: 225mm x 200mm

Cut out size: 150mm x 155mm

Color: White

Net weight: 285g

 

Installation Information:

1, Measure the height from the ground to the lowest part of the cats chest and make a horizontal mark on the door at the correct height.

2, Using a ruler, draw a horizontal line 155mm long at the same level as the previous mark.

3, Using a ruler, draw a vertical line 150mm long at each end of the horizontal line at a 90 degree angle. Finish by drawing the top horizontal line and completing the rectangle.

4, Using a drill, make a hole on the inside of each corner. Then, using a jigsaw, cut out the rectangle following the lines.

5, Sand the rough edges down to make them smooth.

6, Place the cat flap over the hole and mark the position of the screw holes. Drill pilot holes for the screws, position the cat flap into place ensuring the lock is on the inside of the door and tighten the screws using a screwdriver.

 

Package included:

1 x 4 Way Locking Pet Door

1 x Pack of Screws